11
HARD WIRING INSTALLATION
HARD WIRING CONNECTION
If it is necessary to hard wire this appliance, a qualified electrician must remove the cord connection, and wire
the appliance directly to the household wiring.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired. In
the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the
current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
1. Remove the cover plate from the back of the appliance with a Phillips head screwdriver.
2. Locate and disconnect the electrical wires housed behind the cover plate that has been removed, as
shown above.
3. Remove the new cover plate found in the hardware bag. Punch out the 7/8" (22.2mm) hole and install a
box connector through the void, into the junction box. Snap the box connector clamp onto the supply
wires.
4. Referring to figure 3 and using the wire connectors, first connect the green ground wires together (G).
Then, connect the white neutral wires together (N). Lastly, connect the hot black wires together (L).
5. Reinstall the cover plate using the three screws, as shown in Figure 1.
Log / Crystal / Pebble Ember Set Installation
(
NOTE:
Please make the installation according to the ember set which accompanies the fireplace.)
WARNING
TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED SERVICE
PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
