IGM Laguna CFlux 1, Operating Instructions Manual

Page: 7 / 16

-7- www.igmtools.com
Step 5: Secure the base with (3) lower upright support panels to the unit
using (6) 5/16” x 3/4” hex bolts and (6) 5/16” x 1” flat washers.
Step 6. Secure the (3) upright support reinforcement plates using (12)
5/16” x 3/4” hex bolts and (12) 5/16” x 1” flat washers.
Step 7: With the help of another person, lift the unit up carefully and rotate
to the right-side-up with the motor on top and the wheels at the bottom.
Step 8. Secure the lower triangular support plate to the base using (2)
5/16” x 3/4” hex bolts and (2) 5/16” x 1” flat washers. Follow the same
steps for the opposite side.
Step 9. Slide the Foot pedal bar into the opening on the lower upright
support panel. Make sure the end of the bar is on the inside of the
triangular support plate. Follow the same steps for the opposite side.
Step 10. Secure the foot pedal support to the lower upright support panel
using (4) 5/16” x 1/2” carriage bolts, (8) 5/16” x 1” flat washers and (4)
5/16” hex nuts. Next secure the foot pedal bar to this support using (4)
5/16” x 1-3/4” hex bolts, (8)5/16” x 1” flat washers and (4) 5/16” hex nuts.
Follow the same steps for the opposite side.
Step 11: Secure the base of the foot pedal bar to the triangular support
plate by holding the lower support plate vertically up against the foot
pedal bar using (2) 5/16” x 3/4” hex bolts, (4) 5/16” x 3/4” flat washers
and (2) 5/16” hex nuts from the inside out. Follow the same steps for the
opposite side.
Step 12. Attach the two ends of the Octagon foot pedal to the nut on the
foot peddle bar.
Step 13. Secure the topping to the nut on the foot pedal bar. Follow this
step on the opposite side.