IGM Laguna CFlux 1, Operating Instructions Manual

Page: 6 / 16

-6- www.igmtools.com
5. Assembly
5.1 Unpacking
Your 1,5HP Mobile Dust Cyclone comes packed in a single box.
Before attempting to assemble this machine, follow these directions for
unpacking:
1. Carefully cut the banding straps and remove them from the box.
2.Cut along the tape line at the top of the box.
3.Remove all parts from the top of the foam and set aside.
4.Remove the foam packing material from the top of the machine and set
aside for further use, during assembly.
5.Cut the cardboard box (top to bottom) in the four corners for easy
removal of the box.
6.Carefully take out the machine components from the box and set aside.
7.Using the diagram below, ensure that all parts are present and in good
condition.
Description
A. Motor
B. Switch and remote control
C. Dust chute
D. Top upright supports (3)
E. Base frame
F. Canister filter
G. Octagon drum front panel
H. Octagon drum back panel
I. Octagon drum base panel
J. Octagon drum lid
K. Octagon drum foot pedal
L. Lower upright supports (3)
M. Drum insert
N. Upright support reinforcement plate (3)
O. Foot pedal bar (left & right)
P. Foot pedal assembly fittings
P1. Lower triangular support plate (2)
P2. Foot pedal bar support (2)
P3. Lower support plate (2)
Q. Inlet adapter
R. Hardware box (Casters, hardware)
S. Operating and Parts Manual
Report any missing or damaged parts to your dealer or distributor. Prior to
tool assembly and use, read this manual thoroughly to familiarize yourself
with proper assembly, maintenance and safety procedures.
5.2 General Tool Assembly
This step requires two adults. This 3HP Mobile Dust Cyclone is heavy,
be careful when lifting and handling it! Failure to comply may cause
serious injury and/or damage to the machine and/or property!
Tools Required
10 mm wrench / 12 mm wrench / 14 mm wrench
Phillips screwdriver. 4 mm hex wrench / 5 mm hex wrench
To assemble your dust cyclone, follow these steps:
For your own safety, do not connect the machine to the power source until
the machine is completely assembled. Please also make sure that you
read and understand the entire instruction manual.
ASSEMBLY TIME ESTIMATE 4-5 hours
Step 1: Place the empty, top, foam packing insert (which contained the
individual parts) upside-down on the floor. Place the main unit into the
styrofoam insert upside-down. Make sure the unit is centered properly
and resting solidly in the foam insert for the next steps.
Step 2: Remove the base which has been bolted to the (3) top upright
supports.
Step 3: Turn base upside-down and attach the (4) 3” casters to the
underside of the base using (16) 5/16” x 3/4” hex bolts and (16) 5/16” x 18
flat washers.
Step 4. Turn the base over with it standing on the (4) 4” casters and
secure the three lower upright support panels using (6) 3/8” x 3/4” hex
bolts and (6) 3/8” x 7/8” flat washers.
Each lower upright support panel is identified for its specific location.
A – shown with one dot is located on the canister side.
B – shown with two dots is located on the front side
C – shown with three dots is located on the opposite end.
Receiver set
button