IGM Laguna CFlux 1, Operating Instructions Manual

Page: 9 / 16

-9- www.igmtools.com
Step 22. Place the Octagon base panel with casters on the bottom of the
drum and secure using Secure the Octagon base panel to the bottom of
the drum using (22) M5 Sheet metal screws to secure tightly, make sure
the head of the sheet metal screw is on the outside of the drum. Take the
plastic bolt end caps to cover all the bolt ends on the inside of the Octagon
drum base. This step is necessary to prevent any injuries caused by the
sharp end of the bolts.
Step 23. Once completing the assembly, keep the drum laying on its
side to apply silicone to the inside of the drum including the base and the
top rim of the drum before the rubber seal has been attached to seal and
prevent air leakages. You will need to use a caulking gun (not supplied).
NOTE: Sealing the perimeters with silicone is imperative for proper
operation of dust collector and efficient operation!
Step 24. Attach the handles to the top and bottom end on the front panel
with the window display using (4) flat head Philip bolt, (4) 5/16” x 7/8” flat
washers and (4) 5/16” hex nuts.
Step 25: Attach the rubber gasket to the top inner edges of the Octagon
drum. The wider end of the gasket goes up. Use tin snips to trim any
excess rubber gasket after completing the seal.
Step 26. Insert the plastic debris collection bag inside the Octagon drum.
Open and spread out the plastic bag to the corners and edges.
Step 27. Assemble drum insert and place it inside over the plastic bag in
the Octagon drum.
Step 28. Lift the foot pedal bar. Align the Octagon drum window to the
center point of the drum lid and push the drum in. Lower the foot pedal bar
to seal the drum for normal machine operation.
Step 29. Confirm when aligning the drum that both the left and right side
lift plates are over the top of the foot peddle bar assembly before lifting
the foot pedal bar. If not aligned, the drum will not be fully sealed and will
interfere with air flow.