4
www.igmtools.com
Operating instructions EN
FD300 & 600 DOVETAIL JIG
The
FD300 & 600
Dovetail Jig is designed to rout ½” half blind dovetails using a dovetail router bit and a
template guide bushing. The following optional accessories can by used to rout other kinds of joints:
- 6,35mm (¼” ) half blind dovetails
- 8mm (5/16”) box joints
- 12,7mm (½”) box joints
- 12,7mm (½”) through dovetails
- 19mm (¾“) through dovetails
- 32mm dowels joints
Standard
Equipment: FD300
FD600
Joint size:
half blind dovetail 12,7mm (½”)
Max. stock width:
305mm (12”)
610mm (24”)
Stock thickness:
12-25mm (7/16” to 1”)
12-25mm (7/16” to 1”)
Template guide diameter:
15,8mm (5/8”)
15,8mm (5/8”)
Weight:
6,9kg (15.2 pounds)
12,3kg (27 pounds)
Max. dia. of router base:
180mm (7-1/16”)
180mm (7-1/16”)
- EN 1 -
ASSEMBLY
Illustration 3
Thread the screw # 15 into the body from the inside of the extrusion,
using the hex key to tighten the screw. Thread the aircraft-type hex
nut #2 onto screw #15 from the front of the jig. Slip on washer #11 and
screw on the knob #12. Repeat this procedure on the other end of the
jig.
Only for FD300
Attach the edge guides #3 with screws #10. As shown in illustration 11,
these guides should be placed in position “U1” on the top surface of the
jig, and in position “F1” on the face of the jig.
(
see illustration 11
)
3
5
12
4
Only for FD600
Illustration 4-5
Put sliding stop guides #.20 to the body
between the spacers which are mounted
in factory. Fit stop
U-bracket #17 with screw #18 and slightly
tighten female knob #19. Fit edge stops
#3 with screws #10 in position U1 and F1
(
see illustration 12
). Tighten the screws
of the egde stops.
11
