en
15
User manual KING
1
2
3
3.2. Connection and actuation
• Unpack the device and remove the wooden platform from the basis Fig.2 (p.10)
• Remove the protective foil and cardboard sections
• Place the device on an even basis, which is hard enough, and then level it with the help of feet.
• If the user shall obtain a device partially disassembled to secure it during transportation, perform the following
operations, according to Fig. 3 (p.10) and Fig. 4 (p.11)
I. Mount the hooks in rack strips Fig. 3 (p.10)
II. Mount shelves on hooks
III. Place price strips on air guide rings
IV. Place separators (product separators) on shelves
• Clean the whole device with water, of temperature not exceeding 40ºC, with addition of washing liquid. Do not
use surface scratching agents, caustic agents or agents containing chlorine and/or soda!
Do not use water stream to clean the device, only a wet cloth
When the installation in the target location is
fi
nished, the device should be left to rest, for at least 2
hours, before actuation, allowing the cooling agent to settle, which will prevent problems with actu-
ating the cooling aggregate!
WARNING: Prevent the cooling circuit from any damages!
• Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by means
of extension cords or dividers!)
• Turn the main switch on Fig. 5/2 (p.11), which will activate the thermostat, and then the aggregate of the device.
• Set the temperature on the temperature regulator panel Fig 5/1 (p.11) (service details on p.14)
• Turn on the lighting switch Fig. 5/3 (p.11)
Fig.2 Removing the wooden platform
Fig.3 Mounting the hook
in the rack frame
1 - Unscrew the feet from the platform
2 – Remove the wooden platform
3 – Screw the feet in nuts welded to the frame of the device
1 – Screen of the rack
2 – Frame for mounting the hooks
3 – Hook (adjusted to three-degree regu-
lation of the suspension angle)
1
2
3
