REFRIGERATION LTD
Pastry Display Cases
| www.igloorefrigeration.com
13
It is recommended to make a break in the operation
once a month
in order to clean the interior, naturally defrost
the evaporator and clean the condenser, and evaluate the condition for door seal (CURP2)
It is essential to keep the condenser of the device clean. Dirt may hinder the heat exchange, causing mainly an
increase in electric energy consumption and may cause damage of the compressor. In order to clean the
condenser it is necessary to unscrew the sheet metal screws and pull the wind brace out of catch by lifting it up.
Clean condenser lamellas with help of soft brush or paint brush. If the condenser is extremely dirty (blocking of
lamellas) it is indicated to use vacuum cleaner or compressed nitrogen to suck / blow the dirt from between
lamellas.
The seller shall not be held responsible for any condenser damages in the case of non-
observance of condenser cleaning instructions
(This concerns
C2URP2
and
C2URH2
) Door seal should be cleaned solely with clean
water without any cleansing agents and it should be thoroughly dried.
The seal cannot
get into contact with oily substances or grease! Ensure door closed properly during
maintenance procedures.
Test: place a sheet of paper between the seal and the casing and close the door. The
paper should pose a tangible resistance during an attempt to pull it out.
Elements of equipment can corrode as result of improper use and maintenance.
To
prevent damage: Do not allow contact of the with substances containing chlorine and/
or baking soda in different varieties, which destroy the protective layer and components
of the equipment (also includes various stainless steel)
Figure 8 Cleaning the condenser
