7
ASSEMBLY INSTRUCTIONS
You will need to assemble the body frame and the base plate together:
• Remove both the securing nuts from the base plate.
• Insert the power cord through the hole in the middle of the base plate.
• Secure the base plate up to the body frame.
• Secure with the two securing nuts previously removed.
• Fix the power cord in place by slotting it into the designated clips.
Important: When the appliance is in use, it should always be kept vertical
(handle should be at the top.) Putting the appliance in any other position could
be dangerous and cause a potential fire hazard.
Location of the Appliance
• The appliance should be positioned where you most need the warmth.
• Do not locate the appliance under a fixed power point.
• Always ensure that the appliance is placed at least 50cm away from furniture,
curtains, walls etc.
• Do not locate the appliance on a deep pile carpet. This could cause the
appliance to be unstable and cause the Tip Over Safety Switch to operate.
Plugging in the Appliance
Before plugging the appliance into the mains, ensure that your supply voltage
is the same as what is shown on the rating plate of the appliance. Try to avoid
contact between the heater and clothes, household linen, furniture, inflammable
material and the power socket.
OPERATING INSTRUCTIONS
1. Insert the plug into a suitable socket ensuring the lead is neither near the
heat source nor a tripping hazard.
2. Select the number of halogen elements required, 1, 2 or 3, by pressing the
buttons located at the top of the heater.
3. The buttons operate the top, middle and lower elements.
4. To make the heater oscillate press the turn button.
5. To make the heater stop oscillating press the turn button again.
Note: When first used, or after being stored for a long period, smoke may be
emitted for a short while. This is normal.
