4
3. Add coffee powder in to the filter. Usually one cup of coffee needs a level spoon of coffee powder,
but you may adjust according to personal taste. Then close the top lid.
4. Place the glass jug on the warming plate.
5. Plug the power cord into the outlet. The LCD will display “12:00” and the colon will flash.
6. Press on/auto/off button once, the indicator will be illuminated red and the appliance will
begin working.
7. The brewing process can be interrupted by pressing the on/auto/off button twice at any time during
operation, and the indicator will be illuminated blue, after about 15 seconds it will go off.
The appliance will continue brewing once on/auto/off is pressed again.
Note: You can remove the jug, pour and serve at any time. The appliance will stop
dripping automatically, but this should not exceed 30 seconds.
8. Remove the glass jug to serve when it has finished brewing (this is around one minute after the
coffee has stopped dripping.)
Note: the amount of coffee you get will be less than the water you have added as some water
is absorbed by coffee ground.
9. When the process is finished, if you do not want to serve immediately, keep the coffee maker
switched on and the coffee can be kept warm on the warming plate. The appliance power will cut
off automatically after 40mins provided it has not been manually disconnected at the completion
of brewing. For an optimum coffee taste, serve it just after brewing.
10. Always turn the coffee maker off and disconnect the power supply when not in use.
Caution: When pouring coffee, the momentary inclined angle of glass jug should not be more than
45 degrees from the vertical position, pour the coffee slowly until the glass jug is empty, otherwise the
coffee in the glass jug will rush to the bottom of jug lid, and the coffee will flow out from two
edges of the lid and may cause scolding.
AUTOMATIC START FUNCTION
If you do not want the coffee maker to start operation immediately, for example at 5:10pm, you want the
coffee maker to automatically start at 8:15pm. Firstly, follow steps 1 to 5 of the above
section, you can then set the automatic start function as follows:
1. Press PROG button once, the word CLOCK will show at the upper right
corner of the display.
2. Press the HOUR and MIN button continuously to set the present time
(real clock), that is 17:10 (See fig. 1).
Note: the machine uses a 24 hour clock
3. Press PROG button again and the word TIMER shows on upper
left corner of display.
4. Set the delayed starting time by pressing HOUR and MIN button repetitively,
that is 20:15 (see Fig. 2).
5. After setting the pre-set time, press the PROG button once, the word TIMER on
the LCD will disappear. The LCD will now display the current clock. After 15 seconds, the blue
indicator in PROG button will go off.
6. Press the on/auto/off button twice, the indicator will illuminate blue and flash. The LCD will display
the current clock. You may see the automatic start time by pressing PROG twice.
Note: You may cancel the automatic start function by pressing on/auto/off button once to stop the
machine. If you want to brew coffee again immediately, press the on/auto/off button once to start brewing.
If you want to change the automatic start time only, follow the above 1-4 steps again.
When ready the blue indicator will stop flashing and illuminate red, the unit will then start brewing. The
appliance power will cut off automatically after two hours if it has not been manually disconnected at the
completion of brewing.