5
OPERATING INSTRUCTIONS
Before using your kettle
If you are using the kettle for the first time, it is recommended that you clean the inside before use. This
can be done by filling the kettle with water to maximum capacity, boiling the kettle and then discarding
the boiled water down the sink. Wipe the surface with damp cloth.
Note: The max capacity of a kettle is 1.7L
Using your kettle
• Place the kettle on a flat, level surface.
• To fill the kettle, remove it from the power base and open the lid by pressing the lid release button,
ill with the desired amount of water, and then close the lid. Alternatively, the kettle may be filled
through the spout. The water level should not exceed MAX mark or sit below MIN level. Too little
water will cause the kettle to switch off before the water has boiled.
Note: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
• Before closing the lid, check that the removable filter is securely in place.
• Close the lid, ensuring that the lid is firmly in place.
• Position the kettle back onto the power base.
• Connect the plug into a wall socket. Press down the On/Off led indicator switch and the switch
will light up.
• Then the kettle will start to boil the water, once the water has boiled the On/Off switch will turn
off automatically.
• You can turn the kettle off at any time during the boiling process by lifting the On/Off switch. If you
want to boil water again, press down the On/Off switch to restart the kettle.
Note: Ensure that the On/Off switch is free from obstruction and the lid is firmly closed, the kettle will
not turn off if the switch is constrained or if the lid is open.
• Lift the kettle from the power base and then pour the water.
Note: Take extreme care when pouring the water from your kettle as boiling water may result in
severe burns. Do not open the lid while the water in the kettle is hot.
• The kettle will not re-boil until the On/Off switch is pressed down again. The kettle may be stored
on the power base when not in use.
Note: Always disconnect from the wall socket when not use.
Boil Dry Protection
Should you accidentally operate the kettle without water; the boil-dry protection will automatically
switch off the power. If this occurs, allow the kettle to cool before filling with cold water to re-boil.
APPLIANCE OVERVIEW
1. Base
2. Water gauge
3. Body
4. Spout
5. Lid
6. Lid Button
7. Handle
8. On/Off Switch
1.
2.
3.
4.
5.
6.
7.
8.
