![background image](http://html1.mh-extra.com/html/igenix/ig3920/ig3920_user-manual_3954050007.webp)
7
INSTALLATION
Location and Air Circulation
The appliance must stand vertically on a flat, even surface, to level the appliance use the levelling feet by
turning them until the appliance is as level as possible.
Install the appliance in a well ventilated room with an average room temperature of between 18°C
and 38°C. The appliance should not be placed near to sources of heat e.g. cookers, radiators, direct
sunlight or in any unheated rooms e.g. garages, or outhouses, as extreme temperatures will affect the
performance of your appliance.
Do not expose the appliance to damp conditions, open air or rain.
Do not lift the appliance by the pipes or the door when moving.
Never place the appliance in a wall recess, fitted cabinet or furniture as this will not allow adequate
ventilation and cause a potential fire hazard. Allow 10mm of space at the sides of the refrigerator and 20
– 30mm above the refrigerator. Never push the fridge against the wall, leave at least a 10mm gap.
Providing you follow the recommended ventilation requirements you will:
• Increase the life of the fridge.
• Minimise the risk of condensation on the outside of the fridge.
• Minimise operating noises caused by vibration.
Door Fitting
The appliance door can be fitted to open to either the left or the right depending on its location. The
appliance must be tilted and supported in order to carry this out. It is advisable to get some help during
this procedure. Take care when fitting and tightening screws.
To change the direction of the door, please follow these instructions:
Ensure the fridge is unplugged and empty.
1. Lean the refrigerator backwards to an angle of approx. 60°
2. Remove the right adjustable foot and screw.
3. Remove the left foot, door hinge bracket and screws.
4. Slide the door down and off the hinge pin and lift away from the applance.
5. Remove the top hinge right cover carefully with a flat screw driver.
6. Refit the top hinge cover on the left of the door.
7. Remove the hinge pin from the top underneath of the appliance (left side).
8. Refit the hinge pin on the top underneath of the appliance (right side).
9. Align the hinge pin to the hole in the top of the door and slide the door up.
10. Refit the foot, door hinge bracket and screws in the right side.
11. Refit the adjustable foot and screw on the left side.
12. Move the refrigerator carefully back into the upright positiion.
Summary of Contents for IG3920
Page 13: ...13...