10
Door Fitting
The freezer door can be fitted to open to either the left or the right depending
on the location. The appliance must be tilted and supported in order to carry this
out. It is therefore advisable to get some help during this procedure. Take care
when fitting and tightening the screws.
Tools required: Phillips style screwdriver / Flat bladed screwdriver / Hexagonal
spanner
1. Tilt the unit slowly towards the rear and prop it securely. Two people are
required to tilt the unit during the door reversal process.
2. Remove the 2 screw covers first, then undo the screws underneath.
3. Remove the 2 screws on the back.
4. Lift the top cover away from the fridge.
5. Remove the 3 screws, then remove the upper hinge that holds the door
in place. Lift the door and place it on a padded surface to prevent it from
scratching.
6. Swap the bottom bushing and bottom bushing cap of the upper door. The
bottom bushing key must be in the correct position to allow it to be inserted
correctly.
7. Remove the lower screws, hinge bracket and adjustable feet from the unit
bottom.
8. Remove the screw-type adjustable feet from another side of the unit bottom
and transfer it to the corresponding position on the opposite side of the unit
bottom.
9. Reattach the 2 lower screws, hinge bracket and adjustable feet to the
opposite side of the unit bottom. Loosely secure.
10. Carefully set the upper door back into place. Ensure the freezer door is
aligned horizontally and vertically so that the seals are closed on all sides
before finally tightening the top hinge. Insert the hinge bracket and screw it
to the top of the unit.
11. Use a spanner to tighten it if necessary.
12. Put the top cover back and fix it in place with the screws.
13. With the door closed, check that the door is aligned horizontally and
vertically and that the seals are closed on all sides before finally tightening
the bottom hinge. Re-adjust the leveling feet as needed.
