2 / 4
P/N 1073642-EN
• REV
D
• ISS
03JUL22
1
2
3
4
5
6
V
-
V
+
V
-
V
+
Power 1
Power 2
Positive (+) Pin Negative (-) Pin
NS3550
-8T-
2S
-
V2
Pin
2/6
Pin
1/
5
Note
:
The wire gauge for the terminal block should be in the
range from
12
to 24 AWG.
Mounting
Note:
Ensure that the industrial managed switch is mounted
vertically with the power connectors on the top and a minimum
of three inches above and below the switch to allow for proper
air flow. This device uses a convection flow of hot air which
rises and brings cold air in from the bottom and out of the top
of the device. Do not mount the switch horizontally as this does
not allow air to flow up into the device and will result in damage
to the switch. Do not tie DC1 to DC2. DC2 is for secondary
power redundancy. Do not plug DC power into the device while
the AC power cord is plugged in. This is not a hot
-
swappable
switch. Hot
-
swapping this device will result in damage.
DIN-rail mounting installation
T
o replace the wall
-
mount application
with DIN
-
rail application
on industrial gigabit Ethernet switch, refer to
the following
figures
to screw the DIN
-
rail on the industrial gigabit Ethernet
switch
.
To hang the industrial gigabit Ethernet switch, follow the steps
below:
1.
Screw the DIN
-
rail on the industrial gigabit Ethernet
switch
.
2.
Place the bottom of DIN
-
rail lightly into the track.
3.
Ensure that the DIN
-
rail is secured
to
the track.
To remove
the industrial gigabit Ethernet switch
from the track,
carefully
pull out
the bottom
of the DIN
-
rail
to remove it from
the track.
Wall-mount plate mounting
To install the industrial gigabit Ethernet switch
on the wall,
follow the steps
below
.
1.
Remove the DIN
-
rail from the industrial gigabit Ethernet
switch
. L
oosen
the screws to remove the DIN
-
rail.
2.
Place the wall
-
mount plate on the rear panel of the
industrial gigabit Ethernet switch
.
