![background image](http://html.mh-extra.com/html/ifm/pp2000/pp2000_operating-instructions-manual_620848019.webp)
After connection of a sensor the parameters of the sensor are loaded
into the working memory of the PP2000.
The parameters of the sensor remain stored in the working memory of
the PP2000 even if the voltage supply is interrupted. They are only
overwritten if a new sensor is connected.
By storing (
Sto
), the parameters of the sensor are stored in the select-
ed read-only memory (
nr1
,
nr2
or
nr3
) of the PP2000.
page 19
ENGLISH
Copying and storing sensor parameters
1
2
3
4
The current sensor data are
available in the PP2000. The cur-
rent measured value is indicated.
If the sensor is not connected to
the installation, the value "0" is
displayed.
Connect the sensor.
Mode/Enter Set
Mode/Enter Set
Press the
Mode/Enter
button
several times until the “
Sto
” is
displayed.
Press the
Set
button and keep
it pressed.
“
nr
”
flashes
for 5s,
then the available memory
locations are displayed one after
the othe.*
(incremental by pressing briefly or
scrolling by holding pressed).
*A read-only memory with three memory locations is available:
nr1
,
nr2
,
nr3
.
parameters
EPS sensor
Mode/Enter Set
As soon as the requested memory
location is displayed press the
Mode/Enter
button
briefly
(=
acknowledgement).
“
Sto
“
flashes
for a short time.
When “
Sto
“ no longer flashes,
the selected parameters are stored
in the read-only memory.
After 15s the current measured
value is indicated again.