If the sensor is connected to PP2000
• it is supplied with operating voltage by this unit,
• it continuously transfers its data to this unit (measured values, signals
transferred to the evaluation electronics and parameter settings).
Modifications to any parameter values are stored in the sensor after
confirmation. They are effective immediately.
(checks the set parameter values of the sensor)
The output signals of the sensor are provided at the output of the
PP2000.
• The output signal OU2 is directly transferred to OU2 of the PP2000.
• The output signal OU1 is transferred to the PP2000 via the EPS pro-
tocol and is available at OU1.
For the wiring diagram refer to the operating instructions of the sen-
sor.
page 23
ENGLISH
Remote display /
Measured value
Remote display /
Parameter values
Remote evaluation
Remote display, remote evaluation, remote parameter setting
L-
L+
OU1
OU2
Mode/Enter Set
EPS sensor
exchange of data
1
Press the
Mode/Enter
button
several times until the
respective
parameter
is displayed.
Mode/Enter Set
Mode/Enter Set
Press the
Set
button briefly.
The
current parameter value
is dispayed,
then the parameter is displayed
again.
2
3
Read other parameters:
Start again with step 1.
Finish reading:
Wait for 15s or press the
Mode/Enter button until the current
measured value is indicated again.
The current sensor data are
available in the PP2000. The cur-
rent measured value is indicated.
Connect the sensor.
