Object recognition sensor
O2D51x O2D53x
19
8 Operating and display elements
3
4
5
6
2
7
1
Fig. 8: LEDs and button
1:
Multi-function LED (green)
2:
Multi-function LED (yellow)
3:
Ethernet LED (green)
4:
Power LED (green)
5:
OUT1-LED (yellow)
6:
TRG LED (yellow)
7:
Multi-function key
8.1 Signal indications
Multi-function LED (green)
Multi-function LED (yellow)
Description
On
---
Alignment mode active
On
flashes at 1 Hz
Set-up mode active
flashes at 2 Hz
---
Configuration is saved
On for 2 s
---
Configuration successfully saved
flashes at 8 Hz
flashes at 8 Hz
Active mode for configuration transfer from ifm storage
device via multi-function key (
---
flashes at 8 Hz
Error: lock button is active
---
flashes at 8 Hz
Error: configuration failed
Tab. 4: Multifunction LED (green, yellow)
Ethernet LED
Power LED
OUT1-LED
TRG LED
Description
Off
On
Off
Off
Unit is ready for operation.
---
flashes at 0.5 Hz
---
---
No parameters set or parameter
setting was not loaded into the
unit.
On
Off
---
flashes 2x at 0.5 Hz
---
---
Unit is in parameter setting mode.
On
Off
---
On
On
---
OUT1 is switched.
---
On
flashes at 8 Hz
---
OUT1 has a short circuit.
---
On
---
On
Trigger is switched.
---
On
---
flashes at 8 Hz
Trigger has a short circuit.
On
On
---
---
Unit is ready for operation, Ether-
net is connected.
flashes
On
---
---
Ethernet transmitting data.
---
Off
flashes at 8 Hz
flashes at 8 Hz
Unit signals internal error.
---
Off
flashes at 2 Hz
flashes at 2 Hz
Unit signals correctable error. The
error information can be read via
Ethernet.
---
Running light
⇒
Unit booting.
---
Running light
⇐
Unit carrying out firmware update.
Off
Off
Off
Off
No voltage or voltage too low.
Tab. 5: Ethernet, power, OUT1-, TRG LED
