■
■
Pour les réglages, les points suivants sont valables:
• Si lors du réglage, aucun bouton n'est appuyé pendant 15 s,
l'appareil redevient opérationnel sans aucune modification des
valeurs.
• Si le réglage est impossible, les LED rouges clignotent. Puis l'appa-
reil redevient opérationnel sans aucune modification des valeurs.
■
■
Blocage / Déblocage
L'appareil peut être verrouillé afin d'éviter une fausse programmation
non intentionnelle: Appuyer sur les deux boutons-poussoir pendant
10 s (l’appareil doit être en Mode Run). La visualisation s'éteint briève-
ment (confirmation du blocage / déblocage).
Appareil livré: non bloqué.
Si l'appareil est verrouillé il est possible d'indiquer
• le seuil de commutation actuel 1 (appuyer une fois sur le bouton-
poussoir Mode/Enter),
• le seuil de commutation actuel 2 (appuyer deux fois sur le bouton-
poussoir Mode/Enter),
• le réglage de la fonction "surveiller un débit excessif" (appuyer trois
fois sur le bouton-poussoir Mode/Enter).
Après le montage, le câblage et le réglage vérifier le bon fonctionne-
ment de l'appareil. Dès la mise sous tension toutes les LED s'allument
et s'éteignent l'une après l'autre.* L'appareil est ensuite opérationnel.
*Durant ce temps les deux sorties sont commutées en fonction de la pro-
grammation: ON pour la fonction N.O. et OFF pour la fonction N.F.
Indication de défaut:
les 5 LED
à gauche
clignotent lors d’un court-
circuit de la sortie de commutation
S1
; les 5 LED
à droite
clignotent
lors d’un court-circuit de la sortie de commutation
S2.
Maintenance recommandée:
Vérifier périodiquement l’éventuelle
présence de dépôts en bout de sonde. Le cas échéant, les enlever avec
un chiffon doux. Les dépôts adhérant fortement (ex: calcaire) peuvent
être retirés avec un produit acétique de nettoyage usuel.
42
Mise en service / Fonctionnement / Maintenance