27
UK
Basic settings (unit on delivery)
10.2
On delivery of the unit, you must first enter the basic settings� The complete
parameter setting menu cannot be accessed before this�
Malfunctions may occur if wrong basic settings are entered�
Entering the probe length
10.2.1
Apply operating voltage�
►
The initial display
>
is shown�
Change to menu level 2�
►
Select [LEnG], press [SET] for 5 s�
►
[nonE] is displayed�
>
Enter the probe length in cm� Remarks on the determination of the probe
►
length. → 10.7.1.
Press [Mode/Enter] briefly�
►
Setting to the medium
10.2.2
Select [MEdI], press [SET] for 5 s�
►
[nonE] is displayed�
>
Set the requested value:
►
[HIGH] for water and water-based media�
-
[LOW] for oils and oil-based media�
-
Note: In case of doubt, carry out an application test to ensure the setting
which is best for your medium�
Entering the type of probe used
10.2.3
Select [Prob], press [SET] for 5 s�
►
[nonE] is displayed�
>
Set the requested value:
►
[rod] for single probe�
-
[COAX] for coaxial probe�
-
The detection of water and water-based media is possible with the single
•
probe as well as with the coaxial probe�
The detection of oils and oil-based media is only possible with the coaxial
•
probe� Therefore the value [COAX] is preset for the parameter [Prob] when
setting [MEdI] = [LOW]; the value [rod] is not available�
Then the unit changes to the operating mode� For further parameter setting the
menu can be opened� The parameters [LEnG], [MEdI] and [Prob] can be accessed
and modified just like all other parameters�
