CR1213
15
ATTENTION
Wrong connection may cause damage to the device.
u
Observe the safety instructions.
ATTENTION
The short-circuit / reverse polarity protection of the device applies to the operating voltage
connections. A short circuit between operating voltage VBB
X
and USB / Audio / Video might
cause damage to the device.
u
Lay supply and signal cables away from the device using the shortest possible route.
u
Provide all outgoing cables with a strain relief 200 mm behind the cable entry.
Maximum cable lengths:
•
USB ≤ 1.8 m
•
Ethernet ≤ 30 m
•
Video ≤ 30 m
•
Audio ≤ 30 m
Minimum operating quality Audio / Video:
There might be interference to audio/video circuits in the vicinity of strong HF sources or due to ESD.
This may result in audible and visible distortion.
5.5 Operating voltage and circuit breakers
u
The individual electric circuits must be protected in order to protect the whole system.
Automotive spade-type fuses are recommended.
Designation
Connector 1
Operating voltage
Nominal value fuse
Required triggering
characteristics
VBB
15
Pin 119
8...16 V DC and 16…
32 V DC
Ignition-starter switch
3 A
T
fuse
≤ 120 s at max.
6.25 A
VBB
30
Pin 121
8...16 V DC
5 A
T
fuse
≤ 120 s at max.
6.25 A
16…32 V DC
3 A
T
fuse
≤ 120 s at max.
6.25 A
VBB
0
Pin 114
8...16 V DC and 16…
32 V DC
15 A
-
Digital inputs
Pin 115, 116, 89, 97,
110
8...16 V DC and 16…
32 V DC
3 A
T
fuse
≤ 120 s at max.
6.25 A
Tab. 1: Terminal designation to DIN 72552
Supply cables of the inputs can be secured together with the circuit breaker for VBB
15
.
ATTENTION
Load dump and surge without connection of VBB
0
w
Destruction of the device possible!
u
Always connect VBB
0
, even if the outputs are not used or are not available.
