![background image](http://html1.mh-extra.com/html/ifm/ecomat100-cr1055/ecomat100-cr1055_mounting-and-installation-instructions-manual_620639024.webp)
■
Panel mounting with clips (snap-in set EC1452)
Preferably select this type of mounting when the unit is to be laid in the horizon-
tal position as it is only held by the force of the clips.
The angle of inclination of the panel must not exceed 45°.
Note when selecting the mounting location:
To loosen the clips the back of the unit must be accessible.
This type of mounting is suited for materials with a thickness of max. 5 mm.
Mounting steps:
Removing the unit from the panel
To insert the screwdriver between the cut-out of the panel and the clip, the
grooved chamfer of the clips must be fitted with a slot.
PROCESS AND DIALOGUE MODULE
PDM 360
COMPACT
PAGE
24
Insert clips
Press the unit into the cutout
end position
Steps for removal:
1. Insert the screwdriver into the slot of
the clips on the back.
2. Angle the screwdriver and compress
the springs of the clips.
3. Remove the unit from the cutout.
front
back