UK
ClassicController CR0053
9
5 Electrical connection
5.1 Wiring
Wiring
Only connect the connector pins as shown in the pin layout�
Unspecified connector pins remain unconnected�
►
Connect all supply cables and GND terminals�
5.2 Ground connection
To ensure the protection of the device against electrical interference and the
safe function of the device, the housing must be connected to the ground of
the vehicle�
1: Drill hole for ground connection
►
Establish a connection between the device and the ground of the vehicle using
M5 screws�
Screws to be used
5.3 Fuses
►
The individual electric circuits must be protected in order to protect the whole
system�
Description
Potential
Pin no.
Fuse
Supply voltage sensors/module
VBB
S
10
≤ 2 A T
Supply voltage outputs
VBB
O
19
≤ 15 A
Supply voltage via relay
VBB
R
01
≤ 15 A
5.4 Laying the supply and signal cables
►
Basically all supply and signal cables must be laid separately�
►
Screen signal cables in EMC critical applications�
