IFM Ecomat 300 AC1355, Supplementary Device Manual

Page: 53 / 248

DP module 7: Command channel
List of commands in module 7
8-1
8 DP module 7: Command channel
→
page 7-21 , table Overview of the commands in the DP module 7
8.1 List of commands in module 7
Command number
decimal
Hexa-
decimal
Description
→
page
01 01 read master flags 8-2
02 02 change operating mode 8-3
03 03 read current slave configuration 8-4
04 04 read projected slave configuration 8-5
05 05 change projected slave configuration 8-6
06 06 read slave parameters 8-7
07 07 change projected slave parameters (default parameters) 8-8
08 08 read LAS (list of active slaves) 8-9
09 09 read LDS (list of detected slaves) 8-11
10 0A read LPF (list of slaves with periphery fault) 8-12
11 0B read LPS (list of projected slaves) 8-13
12 0C - reserved - –
13 0D read telegram error counter 8-14
14 0E read configuration error counter 8-15
15 0F read AS-i cycle counter 8-16
16 10 change current slave parameters 8-17
17 11 reserved –
18 12 reserved –
19 13 Config all 8-18
20 14 reserved –
21 15 save configuration in flash 8-19
22 16 reset telegram error counter 8-20
23 17 address slave 8-21
62 3E operating mode "continuous command“ 8-22
63 3F no operation command without function 8-23