RFID UHF reader
4
2.3 Electrical connection
Disconnect the device externally before handling it�
The device can be damaged when the operating voltage is switched on and no
LAN cable is connected� Connect a LAN cable to the device before you switch on
the operating voltage�
The connection pins may only be supplied with the signals indicated in the
technical data and/or on the device label and only the approved accessories of ifm
may be connected�
2.4 Tampering with the device
In case of malfunctions or uncertainties please contact the manufacturer� Any
tampering with the device can seriously affect the safety of operators and
machinery� This is not permitted and leads to the exclusion of any liability and
warranty claims�
2.5 Ventilation
During operation the device must be sufficiently ventilated� Install the device only
in places where ventilation is ensured�
With insufficient ventilation there is a risk of fire�
2.6 Environmental conditions
Do not place the device in the vicinity of heating installations, do not expose it to
direct sunlight and do not operate it in wet environments� No objects with open
flames must be placed onto the device� Protect the device against moisture, falling
water drops and splashing water� Observe the environmental conditions indicated in
the technical data sheet�
There is a risk of fire in unsuitable environmental conditions�
2.7 Radiated electromagnetic field strengths
2.7.1 CE marking
The device complies with the applicable requirements to CE�
Brand name: ifm electronic DTE800 and DTE810 RFID UHF reader for Europe
This reader is designed for operation in accordance with EN 302208� When
operating the unit with connected antennas, the human exposure regulations to
EN 50364 are to be observed� Ensure a minimum distance of 23 cm between
antenna and human bodies� During operation (of reader and antenna), cardiac
pacemakers of people in the vicinity of the antenna may be impaired� In case of
doubt, persons concerned should consult the manufacturer of the pacemaker or
their doctor�
The reader's output power is to be reduced depending on the antenna cable length
and the antenna gain�