IFM Electronic AL1900, Device Manual

Page: 39 / 90

39
ifm Device Manual IO-Link Master with PROFINET interface CabinetLine 8 Ports IP 20 (AL1900) 05 / 2018
Configuration PROFINET
>
8.2.4 Configure IO-Link ports
17306
In STEP 7, the following assignment of the PROFINET slots to the IO-Link ports of the device applies:
Slot Subslot IO Link port of AL1900
1 2 X01
3 X02
... ...
9 X08
Each sub-slot can be configured for cyclic transmission of process data with a PROFINET module.
The selected PROFINET module determines the operation type of the IO-link interface and the
configurable parameters.
Overview of the available PROFINET modules:
→ PROFINET modules
(
→ p.
72 )
To add a PROFINET module to a sub-slot:
1 Open device editor
► In "HW Config": Click on IO-Link master.
> The device editor shows the current configuration of the IO-Link master.
2 Add PROFINET module
►
Open hardware catalogue.
► Drag and drop the required PROFINET module of the IO-Link master from the hardware catalogue to the slot.
> The device editor shows the slot with the selected PROFINET module.
3 Set parameters of the PROFINET module
►
Double click on the added slot.
> Window [Properties] appears.
► Select [Paramerters] tab.
> The page shows the current parameter settings of the IO-Link ports.
►
Set the parameters as required (marked with X in table):
Operating mode of the IO-Link
ports Available parameters
Fail Safe
Mode
Pattern
Value
Validation /
Data
storage
Vendor
ID (VID)
Device ID Port cycle
time
IO-Link
Events
DI: Digital input -- -- -- -- -- -- X
DO: Digital output X -- -- -- -- -- X
IO-Link: Input -- -- X X X X X
IO-Link: Output X X X X X X X
IO-Link: Input and output X X X X X X X
Further information about the parameters of the PROFINET modules:
→
Parameters of the
IO-Link ports
(
→ p.
70 )
► Click on [OK] to save the changes.
> Changed settings are applied.
>