IFB WASHER 9KG DRYER 7KG, User Manual

Page: 8 / 36

Inlet hose connection
The washer should be connected to the water mains using new hose sets and old hose sets should not be
reused.
In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water
inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
For Ordinary Tap
Pull down the collar of the inlet
hose to separate it from the
water tap adapter.
Loosen the four screws properly
in order to fit into water tap.
Fit the water tap adapter into
the water tap and tighten the
four screws evenly while
pushing up the adapter so that
the rubber packing can stick to
the water tap tightly.
Remove the tape, and screw
connector B into connector A
tightly.
Connect the inlet hose to the
water tap adapter by pulling
down the collar of the hose end.
Connect the inlet hose adapter
of the hose to the water inlet of
the washer by turning it
clockwise to be fixed tightly.
Connector
Rubber
Packing
Connector
Rubber
Packing
Connector
inlet
TAPE
Connector
Rubber
Packing
Connector
Rubber
Packing
Connector
inlet
Connector
Rubber
Packing
Connector
Rubber
Packing
Connector
inlet
Water tap Adapter B
Water tap Adapter A
Connector
Rubber
Packing
Connector
Rubber
Packing
Connector
inlet
Please check the rubber packing
present inside the inlet hose
adapter of the hose.
For Screw-Shaped Tap
Connect the inlet hose to the
water tap by screwing the
connector tightly.
Connect the connector- inlet
supplied if necessary.
Connect the inlet hose adapter
to the water inlet of a washer
and turn it to be fixed.
Connector
Hose
inlet
Rubber
Packing
Hose
Connector
Connector
Connector
*Check the packing in the inlet
Rubber
Packing
8
All manuals and user guides at all-guides.com