IEMCA SMART 316, Manual For Use And Maintenance

Page: 88 / 166

EN
6 - USE AND OPERATION SMART316
6 - Pag. 14 / 20
6.4.3 Automatic cycle start
• Power the lathe on.
• Turn the main power switch to the position I
(ON).
• Press to start the bar feeder.
• Press to select the manual mode.
• If the bar pusher has been moved while power
supply was disconnected, the bar feeder zero
setting should be performed when turning the
machine on again, as follows:
• with upper guide channels closed or open,
press
IF THE BAR-PUSHER HAS NOT BEEN MOVED WHILE POWER SUPPLY WAS
DISCONNECTED, “ZERO AXIS” CONTROL SHOULD NOT BE PERFORMED, WHEN
TURNING THE MACHINE ON AGAIN.
After carrying out the above-mentioned operations, perform next step:
• Enter the parameter values (refer to the "Keyboard instruction manual" ).
• Press the manual feed key to move the bar fore end close to the cutting tool.
To start machining, press , when the lathe collet is closed. From now on, you will
obtain automatic bar feeding until bars are ended or according to the selected program.
• Empty the remnant collection box during machining. Lift the remnant box over the tank to
remove it.
CAUTION:
do not manually lift loads with weights exceeding those prescribed by the
applicable regulations in force.