IEMCA SMART 316, Manual For Use And Maintenance

Page: 45 / 166

4 - HANDLING AND INSTALLATION SMART316
EN
4 - Pag. 13 / 24
• use a sliding caliper to check alignment near the
sleeve "C" and the spindle "D"; hold a tolerance
of 0.15 mm in all four directions.
• prepare a perfectly straight ground bar, having
an outside diameter equal to the max. spindle
bar passage and a length equal to twice the
coupling distance (see item "B" paragraph
4.4.3);
• place the bar in the guide and cause it to slide
forwards and backwards in the spindle, until
almost reaching the lathe collet area.
POSITIONING ADJUSTMENTS
After checking alignment of the feeder with either
the thread or the bar, any required corrections
should be carried out.
Adjust height by turning the screws in the support
feet; carry out lateral adjustment with calibrated
mallet blows on the sides of plates "E".
During this phase, any adjustment carried out
during levelling should be preserved; therefore, in
most cases, feeder positioning will be the result of
a good adjustment compromise.