EN
2 - INFORMATION FOR USE
KID 80 SIV
2 - Pag. 26 / 71
no. 5 Long feeding safety
During every feeding stage, it checks that the bar
does not go further than the value set in
parameter 6 added to the value set in parameter
5. Should this not occur for any reason, the bar
feeder goes into "ALARM".
If parameter 6 is set to 0, this parameter is not
active.
C - Parameter 5
D - Parameter 6
0 - (Not enabled for first piece); the parameter is active for all feeding operations except for
the first piece.
1 - (Enabled for first piece): the parameter is active for every feeding operation (the facing
phase excepted).
INFORMATION
In the sliding headstock lathe, you can use this parameter to check for any tool
breakages; enter a value of a few millimetres (maximum 5 mm).
INFORMATION:
Setting the subparameter to 1 (Enabled for first piece), the "short piece"
(parameter 4) checks are activated straight after the first piece.
5
no. 5 Long feeding safety
DEFAULT VALUE
PROGRAMMABLE VALUE
Kid 80
Kid 80
0 /
All manuals and user guides at all-guides.com
Summary of Contents for KID 80-IV Touch
