IEMCA Elite Evo 112, Manual For Use And Maintenance

Page: 86 / 188

EN
4 - HANDLING AND INSTALLATION Elite112_220_Evo_SIII
4 - Pag. 26 / 26
DANGER - WARNING:
The bar feeder safety depends on these connections, therefore IEMCA is not
responsible for any possible damage to persons or things, caused by improper
use of the above mentioned signals.
4.8.3 FUNCTION SIGNALS
The bar feeder can send and receive all the signals which are necessary to its correct operation.
These signals are managed by a PLC, and can be grouped into: inputs (signals from lathe to bar
feeder) and outputs (signals from bar feeder to lathe).
The signals that have been implemented are the result of our long experience and allow the
connection with every type of lathe: it is therefore possible that only some of them are used.
IMPORTANT:
for further information, please refer to the interface wiring diagram supplied
with the bar feeder, or contact our Customer Service and Engineering
Department, which is always at your disposal.