IEMCA Elite Evo 112, Manual For Use And Maintenance

Page: 134 / 188

EN
6 - USE AND OPERATION Elite112_220_Evo_SIII
6 - Pag. 20 / 20
6.6.3 Automatic cycle start
• Power on the lathe.
• Turn the main switch to position I (ON).
• Press to start the bar feeder.
• Press , to select the manual mode.
• If the bar pusher has been moved while
power supply was disconnected, the bar
feeder zero setting should be performed when
turning the machine on again, as follows:
• with upper guide channels closed or open,
press .
IF THE BAR PUSHER HAS NOT BEEN MOVED WHILE POWER SUPPLY WAS
DISCONNECTED, “ZERO AXIS” CONTROL MAY NOT BE PERFORMED WHEN TURNING
THE MACHINE ON AGAIN.
After carrying out the above-mentioned operations, perform next step:
• Enter the parameter values (refer to the "Keyboard Instruction Manual").
• Press the manual feed button to bring the bar fore end near the cutting tool.
To start machining, press , when the lathe collet is closed. From now on, you will
obtain automatic bar feeding until bars are ended or according to the set program.
• During machining, empty the remnant recovery box. Remove the box after lifting it over the
tank edge.
A12M_06_002_00