PUZZLE-5030
Page 28
Step 4:
Align the UDIMM so the notch on the memory lines up with the notch on the
memory socket.
Step 5:
Once aligned, press down until the UDIMM is properly seated. Clip the two
handles into place.
To remove a UDIMM, push both handles outward. The memory module is
ejected by a mechanism in the socket.
Step 0:
3.4
CPU Installation (PUZZLE-5030-R Only)
WARNING:
CPUs are expensive and sensitive components. When installing the CPU
please be careful not to damage it in anyway. Make sure the CPU is installed
properly and ensure the correct cooling kit is properly installed.
DO NOT touch the pins at the bottom of the CPU. When handling the CPU,
only hold it on the sides.
To install the CPU, follow the steps below.
Step 1:
Disengage the load lever
by pressing the lever down and slightly outward to
clear the retention tab. Fully open the lever. See
Figure 3-3: Disengage the CPU Socket Load Lever
Summary of Contents for PUZZLE-5030
