prox.pad Installation/Programming Manual
1.8 Items Supplied from the Factory
The following items are supplied from the factory with the initial prox.pad shipment.
●
prox.pad unit
●
Request to Exit (REX) button (also called the “Filler Piece”)
●
Request to Exit Label and Blank Label
●
Antenna Housing and Backplate for mounting
●
2 Pin jumper (installed on connector)
●
Lithium battery (installed in unit)
●
Silicone Rubber “dogbone” for Request to Exit switch
●
Self-Adhering Pads
●
Hex Wrench
●
Wire Harnesses
●
Installation Hardware
●
Quick Start Installer Guide
●
CD with Installation/Programming Manuals
1.9 Items the Installer Must Supply
For each prox.pad unit installation, the installer must supply the following items:
●
Proximity Cards or Keyfobs; The prox.pad unit works with these four types of cards:
•
Prox Card II
•
IsoProx II
•
Duo Prox II
•
Proxkey FOB
●
an appropriately rated linear DC Power Supply (12-15 VDC) (filtered and regulated recommended)
●
the appropriate installation electrical tools
●
Remote Antenna Cable [ALPHA 1294C (22AWG) 4-wire, stranded and shielded] (this is required ONLY if you choose to
remote the antenna 10 feet away from the keypad/controller)
●
Wiegand Interface Cable [ALPHA 1295C] (22AWG) 5-conductor, stranded and shielded] (this is required ONLY if using a
separate Wiegand control panel)
●
Power Supply Cable (18AWG-22AWG) 2-wire stranded (depends on distance)
●
Door Lock Cable (18AWG-22AWG) 2-wire stranded (depends on distance)
●
Door Monitor Cable (18AWG-22AWG) 2-wire stranded (depends on distance)
●
REX Cable (if using remote switch) [ALPHA 2421C 18 AWG or ALPHA 1292C 22 AWG, 2-conductor, stranded and
shielded]
●
Tamper Switch; Either Ademco 945T or PR-20451 magnet and reed switch or equivalent
Page 10 of 86 Document # 6055676, Rev 2.2, D4b