IEI Technology PICOe-PV-D510, User Manual

Page: 55 / 141

PICOe-PV-D510 User Manual
Page 43
way that the notch in the middle of the SO-DIMM must be aligned with the
plastic bridge in the socket.
Step 3: Insert the SO-DIMM . Push the SO-DIMM chip into the socket at an angle. (See
Figure 4-1 )
Step 4: Open the SO-DIMM socket arms . Gently pull the arms of the SO-DIMM socket
out and push the rear of the SO-DIMM down. (See Figure 4-1 )
Step 5: Secure the SO-DIMM . Release the arms on the SO-DIMM socket. They clip into
place and secure the SO-DIMM in the socket. Step 0:
4.4.2 CF Card Installation
NOTE:
The PICOe-PV-D510 can support both CF Type I cards and CF Type II
cards. For the complete specifications of the supported CF cards
please refer to Chapter 2 .
To install a CF card (Type I or Type II) onto the PICOe-PV-D510, please follow the steps
below:
Step 1: Locate the CF card socket . Place the PICOe-PV-D510 on an anti-static pad
with the solder side facing up. Locate the CF card.
Step 2: Align the CF card . Make sure the CF card is properly aligned with the CF
socket.
Step 3: Insert the CF card . Gently insert the CF card into the socket making sure the
socket pins are properly inserted into the socket. See Figure 4-2 . Step 3: