![background image](http://html.mh-extra.com/html/siemens/zic-2c/zic-2c_installation-instructions_383571001.webp)
Siemens
Siemens
Siemens
Siemens
Siemens Industry
Industry
Industry
Industry
Industry,,,,, Inc.
Inc.
Inc.
Inc.
Inc.
Building
Building
Building
Building
Building T
TT
TTec
ec
ec
ec
echnologies Di
hnologies Di
hnologies Di
hnologies Di
hnologies Division
vision
vision
vision
vision
P/N 315-048671-3
INTRODUCTION
The Model ZIC-2C from Siemens Industry, Inc., adds
support for 2 channel audio to the ZIC-8B card. The
ZIC-2C replaces the signal routing board that is
installed on the ZIC-8B in the factory. The ZIC-2C
mounts in the same location as the signal routing
card and utilizes the same mounting hardware. Three
8 pin headers and one 20 pin header are also reused
with the ZIC-2C.
INSTALLATION
Remove all system power before installation, first battery then AC. (To power up,
connect the AC first, then the battery.)
1.
If the ZIC-8B is installed in the FireFinder XLS/Desigo Fire Safety Modular/
Cerberus PRO Modular card cage (CC-5/CC-2) remove it now. If you are
using a new ZIC-8B remove it from it’s carton.
2.
Remove the signal routing card from the ZIC-8B by removing the screws in
the two mounting standoffs and gently pulling the signal routing card out of
the connectors on the ZIC-8B. Save the screws. The two mounting stand-
offs should remain attached to the ZIC-8B.
3.
Make sure that the three 8 pin headers and one 20 pin header between the
ZIC-8B and the signal routing card remain installed in J4, J5, J10 and J11 of
the ZIC-8B. If these headers stayed with the signal routing card remove
them and re-install them into the ZIC-8B. Check that each header is com-
pletely seated in the receptacles on the ZIC-8B. (Refer to Figure 2.)
4.
Discard the signal routing card.
5.
Being careful to align all of the headers and the mounting standoffs, gently
press the ZIC-2C down until the headers and standoffs fully mate. Check
that all of pins of the headers are inserted into the sockets on the ZIC-2C
and the ZIC-8B. Secure the ZIC-2C by reusing the two screws from Step 2.
6.
Install the ZIC-8B into the card cage ( CC-5/CC-2 ).
Figure 1
ZIC-2C Two Channel Audio
Enhancement Card
2 Channel Audio Enhancement Card for the ZIC-8B
Installation Instructions
Model ZIC-2C