PAC-1700G QIG IEI Technology Corp. Page 6
Figure 16: Run Front Panel Cables through the Space
Step 3:
Reinstall the upper compartment and reinsert the four
previously removed upper compartment retention
screws.
Step 0:
STEP 8: BACKPLANE INSTALLATION
Compatible IEI backplanes are listed below:
Model No.
SBC Type
PCI
ISA
PSU
IP-7SA-RS-R30 PCISA
4
2 AT
PCI-7S-RS-R30 PICMG
1.0
4
3 AT/ATX
Table 3: Compatible IEI Backplanes
To install the PCI-7S-RS-R30 backplane, please follow the
instructions below:
Step 1:
Insert copper pillars into the shorter elevated predrilled
screw holes corresponding to the PCI-7S-RS-R30
backplane retention screw holes.
Figure 17: Copper Pillars
Step 2:
Mount the backplane onto the base of the upper
compartment. Make sure the backplane is positioned so
that when the CPU card and PCI/ISA expansion cards
are installed, both the CPU card and the PCI/ISA card
I/O connectors face the rear of the chassis.
Step 3:
Align the PCI-7S-RS-R30 backplane retention screw
holes with the retention screw holes in the elevated
predrilled retention screw holes and the copper pillars in
the base of the upper compartment.
Step 4:
Insert nine retention screws to secure the backplane to
the chassis.
Step 5:
Connect the power cable to the backplane.
Step 0:
To install the IP-7SA-RS-R30 backplane, please follow the
instructions below:
Step 1:
Insert copper pillars into the shorter elevated predrilled
screw holes corresponding to the IP-7SA-RS-R30
backplane retention screw holes.
Figure 18: Copper Pillar
Step 2:
Mount the backplane onto the base of the upper
compartment. Make sure the backplane is positioned so
that when the CPU card and PCI/ISA expansion cards
are installed, both the CPU card and the PCI/ISA card
I/O connectors face the rear of the chassis.
Step 3:
Align the IP-7SA-RS-R30 backplane retention screw
holes with the retention screw holes in the elevated
predrilled retention screw holes and the copper pillar in
the base of the upper compartment.
Step 4:
Insert five retention screws to secure the backplane to
the chassis.
Step 5:
Connect the power cable to the backplane.
Step 0:
STEP 9: 3.5
＂
HDD INSTALLATION
The PAC-1700G chassis supports two 3.5” HDDs on the right side of
the chassis. To install an HDD, follow the steps below:
Step 1:
Remove the four 3.5” HDD bracket retention screws on
the right side of the chassis.
Figure 19: 3.5
＂
HDD Bracket Retention Screws
Step 2:
Slide the 3.5” HDD bracket upwards to remove the
bracket.
Figure 20: Slide the 3.5
＂
HDD Bracket Upwards
Step 3:
Mount a 3.5” HDD onto the 3.5” HDD bracket.
