IEI Technology NANO-8522, User Manual, Page: 99 / 249

NANO-8522 EPIC Board
Page 79
5.2.1 Installation Notices
WARNING:
The installation instructions described in this manual should be
carefully followed in order to prevent damage to the NANO-8522 and
injury to the user.
Before and during the installation please DO the following:
Read the user manual :
o
The user manual provides a complete description of the NANO-8522
installation instructions and configuration options.
Wear an electrostatic discharge cuff (ESD) :
o
Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.
Place the NANO-8522 on an antistatic pad :
o
When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
Turn off all power to the NANO-8522 :
o
When working with the NANO-8522, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the system.
Before and during the installation of the NANO-8522 DO NOT do the following:
DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.
DO NOT use the product before verifying all the cables and power connectors
are properly connected.
DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.
5.2.2 Installation Checklist
The following checklist is provided to ensure the NANO-8522 is properly installed.