IEI Technology NANO-8522, User Manual, Page: 106 / 249

NANO-8522 EPIC Board
Page 86
5.3.3 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the NANO-8522. Please make sure the purchased SO-DIMM complies
with the memory specifications of the NANO-8522. SO-DIMM
specifications compliant with the NANO-8522 are listed in Chapter 2.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below and refer to
Figure 5-7 .
Figure 5-7: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket . Place the NANO-8522 on an anti-static pad with
the solder side facing up.
Step 2: Align the SO-DIMM with the socket . The SO-DIMM must be oriented in such a
way that the notch in the middle of the SO-DIMM must be aligned with the
plastic bridge in the socket.
Step 3: Insert the SO-DIMM . Push the SO-DIMM chip into the socket at an angle. (See
Figure 5-7 )
Step 4: Open the SO-DIMM socket arms . Gently pull the arms of the SO-DIMM socket
out and push the rear of the SO-DIMM down. (See Figure 5-7 )