IEI Technology KINO-AH612, User Manual

Page: 59 / 165

KINO-AH612
Page 48
Setting Description
Short 1-2 ATX Mode Default
Short 2-3 AT Mode
Table 4-2: AT/ATX Mode Select Jumper Settings
The location of the AT/ATX mode select jumper is shown in Figure 4-9 below.
Figure 4-9: AT/ATX Mode Select Jumper Location
4.4.2 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header
Jumper Settings: See Table 4-3
Jumper Location: See Figure 4-10
If the KINO-AH612 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ
Enter the correct CMOS setting
ƒ
Load Optimal Defaults