IEI Technology IVS-300, User Manual

Page: 30 / 107

IVS-300 Embedded System
Page 16
Step 2:
Install WLAN/WWAN module and SIM card (optional)
Step 3:
Install SATA SSD
Step 4:
Mount the IVS-300
Step 5:
Connect the peripheral devices
Step 6:
Power the system up
Step 0:
3.4 Disassemble the system
WARNING:
1. Over-tightening bottom cover screws will cause damage to the bottom
surface. Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
2. Never disassemble the system while power is still being fed into the
system. Before disassembling the system, make sure the system has been
turned off and all power connectors unplugged.
Before the internal component can be installed, the system must be disassembled to
access the main board. To disassemble the system, please follow the steps below:
Step 1:
Turn the IVS-300 over.
Step 2:
Remove the bottom panel retention screws to detach the bottom panel from the
chassis (
763
Figure 3-1
).