IEI Technology IVS-300-BT-J1/4G, User Manual

Page: 48 / 110

IVS-300 Embedded System
Page 34
3.10.4 GPS Speed Pulse/Direction Connection
The IVS-300 has a 2-pin connector for GPS speed pulse/direction connection. The pinouts
for the GPS speed pulse/direction connector are listed in the figure and table below.
Figure 3-25: GPS Speed Pulse/Direction Connector
PIN NO. DESCRIPTION
1 Direction
2 Speed Pulse
Table 3-7: GPS Speed Pulse/Direction Connector Pinouts
3.11 Power-On Procedure
3.11.1 Installation Checklist
WARNING:
Make sure a power supply with the correct input voltage is being fed into
the system. Incorrect voltages applied to the system may cause damage to
the internal electronic components and may also cause injury to the user.
To power on the embedded system please make sure of the following:

The bottom cover is installed

All peripheral devices (monitors, serial communications devices etc.) are
connected

The power cables are plugged in

The system is securely mounted