IEI Technology IMBA-XQ354, User Manual

Page: 97 / 245

IMBA-XQ354 Motherboard
Page 77
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge that is
used to close an electrical circuit. It
consists of two metal pins and a small
metal clip (often protected by a plastic
cover) that slides over the pins to
connect them. To CLOSE/SHORT a
jumper means connecting the pins of
the jumper with the plastic clip and to
OPEN a jumper means removing the plastic clip from a jumper.
Before the IMBA-XQ354 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the IMBA-XQ354 are listed in
9
Table 5-1 .
Description Label Type
Clear CMOS J_CMOS1 3-pin header
COM3 Pin 9 setting J_COM_F3 3-pin header
COM4 Pin 9 setting J_COM_F4 3-pin header
COM5 Pin 9 setting J_COM_F5 3-pin header
COM6 Pin 9 setting J_COM_F6 3-pin header
COM3 Pin 9 voltage setting J_COM_V3 3-pin header
COM4 Pin 9 voltage setting J_COM_V4 3-pin header
COM5 Pin 9 voltage setting J_COM_V5 3-pin header
COM6 Pin 9 voltage setting J_COM_V6 3-pin header
SPDIF out selection SPDIF_OUT 3-pin header
Table 5-1: Jumpers
Jumper