IEI Technology AFL3-W15C, User Manual

Page: 56 / 144

AFL3-W15C/W19C-ULT3 Panel PC
Page 40
3.12.3 Cabinet and Rack Installation
The AFL3-W15C/W19C-ULT3 flat bezel panel PC can be installed into a cabinet or rack.
The installation procedures are similar to the panel mounting installation. To do this,
please follow the steps below:
NOTE:
When purchasing the cabinet/rack installation bracket, make sure it is
compatible with both the AFL3-W15C/W19C-ULT3 flat bezel panel PC
and the rack/cabinet into which the AFL3-W15C/W19C-ULT3 is
installed.
Step 1:
Slide the rear chassis of the AFL3-W15C/W19C-ULT3 panel PC through the
rack/cabinet bracket until the frame is flush against the front of the bracket.
Step 2:
Insert a M5*50 screw into the screw hole on the side of the rack mounting
bracket. Then, install the following components onto the screw in sequence.
See
Figure 3-26
.
Sequence Item Photo Instruction
1 Spring Install a spring onto the screw.
2 Nut Tighten a nut until the spring is
compressed enough for plastic cap.
3 Plastic
cap
Tighten a plastic cap onto the end of
screw thread.
Step 3:
Repeat
Step 4
to install the other three screws into the sides of the two rack
mounting brackets.