IEI Technology AFL3-W07A-BT-N1, User Manual

Page: 32 / 109

AFL3-W07A-BT-N1 Panel PC
Page 20
3.6.2 Serial Device Connection
Follow the steps below to connect a serial device to the DB-9 connector of the
AFL3-W07A-BT-N1 panel PC.
Step 1: Locate the DB-9 connector . The location of the DB-9 connectors is shown in
Chapter 1 .
Step 2: Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector on the bottom panel. See
4
Figure 3-7 .
Figure 3-7: DB-9 Serial Port Connector
Step 3: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
3.6.3 USB Device Connection
NOTE:
User must install the USB 3.0 driver before connecting a USB device to
the system or else the system may not recognize the connected
device.