IEI Technology AFL2D-12A-N270-ECIL, User Manual

Page: 39 / 147

AFL2D-12A-N270-ECIL Panel PC
Page 39
Step 5:
Connect the SATA cable to the rear of HDD and the SATA connector on the
motherboard.
Step 6:
Install the HDD into the AFL2D-12A-N270-ECIL by aligning the retention screw
holes in the HDD brackets with the retention screw holes on the chassis. Insert
the four retention screws.
Step 7:
Replace the aluminum back cover to the chassis.
Step 8:
Replace the plastic back cover.
Step 0:
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
4.6 AT/ATX Mode Selection
AT and ATX power modes can both be used on the AFL2D-12A-N270-ECIL. The
selection is made through an AT/ATX switch on the aluminum chassis inside the plastic
back cover (Figure 4-6). To select AT mode or ATX mode, follow the steps below.
Step 1:
Remove the plastic back cover. See
Section 4.4
above.
Step 2:
Locate the AT/ATX switch on the aluminum chassis (
Figure 4-6
).
Figure 4-6: AT/ATX Switch Location