IECHO TK4S, User Manual

Page: 62 / 71

58
6.4. Big Creasing Tool
Picture 27 Picture 28

Insert the big creasing wheel holder into the cutting head (Pic 27), make sure the red dot of creasing wheel holder
aligned with the red dot on cutting head, then insert it into the hole on the head.

Confirm the big creasing wheel holder into the cutting head in place, then tighten the screw on the head with clockwise
(pic 28).
Picture 29 Picture 30

Put the wheel in the rectangular slots of holder (pic 29)

Push the wheel with hand, if no fall, it indicates installation is finished (pic 30)