- 15 -
6.
Operation guide
6.1.
Set up
The CW-5HD does not include the various accessories that may be used in its
operation. Please separately access the following items as needed for your
specific application prior to use.
z
BNC cable for HD-SDI or SDI signal connectivity
z
IDX ENDURA system batteries or external power supply
Note: Power supply; Use only an AC adaptor, or batteries, with a DC
output of 11V – 17V. The CW-5HD DC-IN connector is XRL-4P male, pin
assign no.1: negative (-), no.4: positive (+). Do not apply over-voltage
or reverse-polarity voltage since they can cause failure or damage.
6.2.
Operating procedures
①
Connect CW-5HD TX to the video camera or other transmitting devices
battery source and CW-5HD RX to the receiving monitor’s battery mount.
If either device does not have a V-Mount, use the applicable adapter.
②
Connect video device’s SDI output connector to CW-5HD TX SDI input
connector with a BNC cable. Next, connect the CW-5HD RX SDI output
connector to the monitor’s SDI input with BNC cable.
The CW-5HD TX has an SDI output connector, which can be connected to
a monitor for the video source if required. The CW-5HD RX has two
output connectors therefore two monitors, recorders, etc can be
connected simultaneously.
③
Connect fully charged ENDURA batteries to CW-5HD TX and CW-5HD RX.
When an external power supply is used, connect to DC-IN connector.
Note:
When an ENDURA battery is used, power is supplied to both
CW-5HD and video camera / monitors etc. When external power supply
is used at the DC-IN XLR, power is supplied only to CW-5HD. Video
camera, monitors etc must be powered from another source.
④
Set the FREQ SELECT switch, POWER MODE switch, UNI/MULTI switch of
CW-5HD TX in appropriate modes. Set the UNI/MULTI switch of CW-5HD
RX in appropriate mode.
⑤
Turn the power ON.
