Innovative DisplayWorks, Inc.
Instruction Manual
4
5
G-26c/GCG-26c
Innovative DisplayWorks
offi ce 909.447.8254 • fax 909.305.8756 • toll free 877.307.2665 • www.idw.global
PARTS & IDENTIFICATION
Last Revised: September 25, 2019 12:17 PM
G-26c/GCG-26c
1. Top Plastic Strip of Glass Door
2. Glass Door
3. LED Light in the Glass Door
4. Door Handle
5. Low Plastic Strip of Glass Door
6. Door Limiter
7. Door Switch on Glass Door
8. Door Support
9. LED Light Cover (4)
10. Door Gasket
11. Side Panel
12. Fan Support
13. Evaporator Fan
14. Water Container
15. Control Panel
16. Fan Guard
17. Lamp Stand
18. LED Light
19. Thermostat
20. Sensor
21. Thermostat Panel
22. LED Light Cover
23. Shelf (6)
24. Shelf Clips (24)
25. Pilasters (4)
26. Evaporator
27. Return Pipe
28. Return Pipe Cover
29. Thermometer
30. Grill
31. Inserts
32. Light Canopy Cover
33. Top Strip Inside Light Canopy
34. Outline Border of Light Canopy
35. Low Strip Inside Light Canopy
36. Foam Cabinet
37. Top Frame of Light Canopy
38. Left and Right Support of Light
Canopy (2)
39. LED Light Inside Light Canopy
40. Top Hinge
41. Low Frame of Light Canopy
42. Plenum
43. Bracket for Grill
44. Magnetic Switch
45. Lower Hinge
46. Electric Box Cover
47. Transformer for LED Light
48. Electric Box
49. Electric Relay
50. Connecting Tube for Filter Dryer
51. Filter Dryer
52. Power Cord
53. Connecting Tube for Condenser
54. Condenser
55. Drain Pan
56. Compressor
57. Condenser Fan
58. Filter Dryer Bracket
59. Upper Baseboard
60. Fan Support
61. Lower Baseboard
62. Leveling Legs (4)
63. Bumper Block (2)
64. Compressor Guard
65. Light Switch (2)
66. Bracket for Light Switch
67. LED Controller
68. Power Supply Cover
G-26c/GCG-26c
1. When using this appliance, always follow
the basic safety precautions:
2. Read the entire User’s Manual before
operating this appliance.
3. Use this appliance only for its intended
purpose as described in this User’s Manual.
4. This appliance must be properly installed
in accordance with the installation
instructions before being used.
5. IDW requires that a dedicated circuit be
used for the unit. Failure to do so voids
warranty.
6. Never unplug your cooler by pulling on the
power cord. Always grasp the plug fi rmly
and pull it straight out from the outlet.
7. Unplug your appliance before cleaning or
making any repairs.
Note: If for any reason
this product requires service, we strongly
recommend that a certifi ed technician
perform the service.
8. When disconnecting the power source,
wait at least 5 minutes to reconnect the
power to avoid damage to the compressor
and the cooling system.
9. Immediately repair or replace all electrical
cords that have become frayed or other-
wise damaged. Do not use a cord that
shows cracks or abrasion damage along its
length, the plug or the connector end.
10. Do not operate or store your appliance
near or around explosive fumes, gasoline
or other fl ammable vapors and liquids.
11. Do not use fl ammable liquids to clean unit.
12. Setting the temperature control to the
0 position does not remove power to
the light circuit, perimeter heaters, or
evaporator fans.
13. Do not adjust the temperature control.
The temperature control is factory set for
maximum performance.
SAFETY INSTRUCTIONS
PLEASE SAVE THESE
INSTRUCTIONS!
DANGER!
PROPER DISPOSAL OF THE
REFRIGERATOR
Pre-Caution, Non-Operating Coolers
Should Have:
1. Door removed.
2. Shelves kept in place in order
to prevent any small child from
climbing inside cooler.
For Proper Disposal of Cooler:
Distributors/retailers need to contact
a qualifi ed service technician:
1. To recover all refrigerant from
the cooler
2. To remove the compressor
or remove the oil from the
compressor
Then the distributor/retailer can
contact their local metal recycling
center to pick up the remaining
cabinet, shelves, etc. By law, disposal
of hazardous wastes may be subject
to fi nes and imprisonment under
the provisions of the environmental
regulations. For more information
please visit: http://www.epa.gov/
osw/hazard/index.htm
