6
6. Installation
6-1. Mullion/Wall Mount:
Drill 6-32 or M3 screws hole at 3.3" (8.38cm) intervals vertically
And drill one 1/2" hole between previously drilled two holes for the reader cable 1.7" apart from the
top hole.
(If the gang box is already installed on the wall then skip this step.)
6-2. Fixing a Tamper Magnet to the wall
Attach a tamper magnet with tools such as double-sided tape on the left of the bottom hole that you
drilled in 6-1. (Refer to the figure below)
6-3. Fixing Reader Module
Put reader cable into the center hole and fix the reader module using two 6-32 or M3 screws.
6-4. Putting on the Cover
Put on cover into the reader module, and then push it until hearing the locking sound.