IDTECH VersaScan II, User Manual

Page: 55 / 80

52
33
*.G021$*
*.G022$*
*.B026$*
*.B027$*
PDF417
IDLE MODE
*.B028$*
1. Idle Mode is only supported by certain models.
2. When Idle Mode is on, the scanner will enter idle state to save
power if there is no activity after Idle Entry Mode Time elapses
(the default is 1 min).
3. You can set the value of Idle Entry Mode Time by the following
three steps:
Step 1: scan Idle Entry Mode Time
Step 2: scan one digits(Limit Range: 1~9 Min.) from the numeric
table below.
Step 3: scan Idle Entry Mode Time
1. The scanner will beep three times as a reminder that a setting is
not yet complete.
2. If you make a mistake, forget a step, etc., scan RESET to start again.