IDTECH VersaScan II, User Manual, Page: 15 / 80

12
1. The default Deactivation Time is 3 Sec.
2. Deactivation Time is the time interval between the last scan and
the automatic deactivation of LED in Auto-Sensing Mode.
3. You can set the Deactivation Time value by the following three
steps:
Step 1: scan Deactivation Time
Step 2: scan two digits(Limit Range: 01 ~ 30sec.) from the numeric
table below.
Step 3: scan Deactivation Time
DEACTIVATION TIME
. F030$
DEACTIVATION TIME
1. The scanner will beep three times as a reminder that a setting is
not yet complete.
2. If you make a mistake, forget a step, etc., scan RESET to start again.